BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Starting and Driving

Starting and Driving 164 4L: Four-wheel drive low-gear, four-wheel drive, can be used on off-road roads requiring low speed and high traction for a short time, and is not allowed to be used on dry or paved roads. Gears shift In order to avoid the failure of the transfer case caused by misoper­ ation, the electronically controlled transfer case of this model does not support the installation of wheel clutch on the vehicle! In the 2H gear, the instrument light does not light up. When the transfer case is switched, the current gear is always on and the target gear is flashing. If the 4H gear is switched to the 4L gear, the 4H light on the instrument is always on, and the 4L gear is flash­ ing.

After the shift is completed, the 4H light is off and the 4L light is always on. Attention 4L S 110.1 hpa 2437 m Switching between 2H and 4H: 3 During the driving process of the vehicle (the required speed is lower than 30km/h), the driver can switch between 2H and 4H at will without stopping the vehicle, but it should be done when driving in a straight line at a constant speed. The current gear position of the time- sharing four-wheel drive transfer case is displayed in the upper left "4L" position in the display of the combination instrument. Switching between 4H and 4L: 1. Stop the vehicle and keep the engine running 2.

Depress the clutch pedal or move the shift lever to the N position; 3. Rotate the transfer case shift switch to 4L or 4H. Note: For MT models, do not lift the clutch before the transfer case shift is completed; during the shift process, the target gear flashes, and after the gear shift is completed, the target gear is always on.