BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Starting and Driving

Starting and Driving 163 operation steps of the above methods to restore the transmission emergency unlocking handle to its original position. Mode II * When this fault occurs, it is recom­ mended to contact the authorized dealer of BAIC, and the professional will operate to remove the fault. Doing it yourself may damage vehicle-relat­ ed components. When the transmission needs to be unlocked in an emergency, it means that there is a problem with the vehi­ cle and needs to be checked and re­ paired at a authorized dealer of BAIC. Attention Attention 4H Forced release of transmission "P" gear for a long time should be avoid­ ed.

In the case of forcibly releasing the "P" gear of the transmission, the transmission is not locked. If you need to stop the vehicle, you must use the parking brake or step on the brake pedal. 2H 4L START ENGINE STOP 3 M 1. Apply parking brake.. 2. Rotate the transmission emergency unlocking handle counterclockwise to make it enter the sliding slot. 3. Pull the rope on the handle outward, Electronically controlled four- wheel drive transfer case This vehicle is equipped with electronically controlled four-wheel drive transfer case, which has the following gears: 2H: Two-wheel drive, high-grade, rear- wheel drive, used under normal driving conditions, without four-wheel drive. 4H:

Four-wheel drive high-grade, four- wheel drive, can be used in rain, snow, muddy, gravel areas or general cross- country roads for a short time, and is not allowed to be used on dry or paved roads. Mode I * pull it to the outermost side, rotate the transmission emergency unlocking handle clockwise, and there will be a slight "click", indicating that the handle position has been fixed, and the transmission is in the "P" gear unlocking state. At this time, the vehicle will give an alarm, the instrument will display "transmission parklock failure", and the transmission fault light will be on. At this time, the transmission is in "N" gear. 4.

After the vehicle is moved, please 4H 2H 4L S START ENGINE STOP immediately follow the reverse