Brake system 168 important to keep enough distance from other vehicles. Of course, the actual braking distance will vary depending on the road surface (eg paved or sandy), road conditions (wet, dry, icy), tire tread, braking vehicle weight, and braking force. Do not apply the brake pedal urgently when it is not required. Some drivers drive too uncontrollably. For example, they step on the accelerator pedal and then the brake pedal, failing to keep pace with the speed of traffic flow. This is a wrong approach. The brakes do not have time to cool down between consecutive emergency braking, and if the brake pedal is frequently pressed hard, it will accelerate the wear of the brakes.
Keeping pace with the traffic flow and keeping a certain distance between vehicles will greatly reduce unnecessary emergency braking, which will improve the braking effect and prolong the brake life. If the engine stalls during driving, the normal braking shall be adopted but the inching braking shall not be adopted, otherwise it will be difficult to step on the brake pedal. Even if the engine is stopped, there is still some brake assistance for braking, but it will be consumed during braking. Once the brake power is exhausted, the braking time will be prolonged, and it will be more difficult to step on the brake pedal. Factors affecting the braking effect 1.
Abrasion The wear of brake friction plates depends to a great extent on the use mode and driving conditions, especially for those cars that often travel in urban traffic and short distances or drive in sports mode. Therefore, within the prescribed time interval of maintenance, it is very necessary to go to the special dealer of BAIC to check the thickness of brake friction plates. When driving downhill, you should change gears in time to make use of the braking force of the engine, which can reduce the burden on the brakes. To increase braking force, do not brake continuously but intermittently. 2.
Moist or sprinkled salt Under certain driving conditions, such as driving in water, rain, or after washing the car, due to the freezing of brake discs and friction discs due to humidity or low temperature in winter, the braking effect will lag, so it is necessary to brake several times first and dry the brakes. 3