Brake system 179 HBA brake assist* HHC Hill-start hold control * HDC Hill Descent Control* The brake assist system is used to optimize the braking force. The brake assist system helps to increase the braking force and thus shorten the braking distance. When the driver presses the brake pedal very quickly, the brake assist system will automatically adjust the braking force to the maximum until ABS carries out control intervention. The brake pedal must be depressed until the required braking is completed. Once the brake pedal is released, the brake assist system switches off automatically. In case of ABS failure, the brake assist system is also unavailable.
After the driver fastens his seat belt and closes the driver's side door, When the slope is greater than 4 degrees, Whether you stop when going uphill and then move forward, Or reverse after stopping when going downhill, the ramp starting auxiliary system automatically comes into work at any time and releases the brake. The braking system will still provide powerful braking force in about 0.5 ~ 2 seconds, ensuring the braking of the vehicle, preventing the vehicle from sliding on the slope, making the driving smooth, and no longer having the trouble of sliding backward, and greatly improving the comfort and control safety.
HDC hill descent control allows the vehicle to maintain a constant speed when going downhill. The hill descent function is an additional function of the ESP system. It can be used when the driver wants to maintain a constant speed (when the transfer case is 2h/4h, the range is 8km/h ~ 35km/h; when the transfer case is 4L, the range is 4km/h ~ 35km/h) downhill. Operation mode of hill descent function: 1. Press the HDC switch to start the 3 hill descent function. At this time, the instrument green HDC light is on, indicating that the HDC function is on and in standby state; Press the HDC switch again to turn off the HDC function; 2.
When the HDC function is turned on and the vehicle is on a downhill slope, the driver does not perform braking and acceleration operations, and the vehicle driving speed is 4km/h (transfer case 4L) /8km/h (transfer case 2h/4h) ~ 35km/h; The hill descent function starts to work, and the vehicle can drive at the initial speed; At this time, the green HDC light of the instrument will be flashing;