Driving skills 187 After starting the engine Running-in period driving Run-in engine Fuel leakage: Park the vehicle for a while, and check the vehicle bottom for fuel, oil, water or other fluid leakages. If the air- conditioning drips after being used, this is normal. In Driving To ensure your vehicle’s service life, pay extra attention to how you drive at the initial stage before putting your vehicle into normal use. Specifications in running-in period: Drive on good roads under reduced load at limited speed. Avoid full-throttle starts and rapid accel eration. Do not brake sharply: Implement the operational regulations strictly and keep the engine at normal working temperature.
Do not change the oil until the scheduled maintenance time. Do well in the routine vehicle mainte nance work seriously, and always check and tighten the external fastening bolts and nuts. Pay attention to the sound and temperature changes of various as semblies during operation, and perform adjustment timely. A new engine must be run in for 1500 km. Within the first 160km, the vehicle speed should be lower than 80km/h, and within the first 800km, the vehicle speed should be lower than 90km/h. During the running-in period, the following should be observed: After a cold start, run for 15 seconds before starting to drive.
During the initial driving period, you should avoid driving at full throttle, at the highest speed, at the same speed for a long time or running at high idle for a long time. During the first drive, it is generally not necessary to make adjustments to the engine. It is not necessary to change the oil or oil filter before the specified first service mileage is reached, unless the workload is very heavy. It is not necessary to change the oil or oil filter until the vehicle mileage has reached the specified first service mile age, unless the vehicle is under heavy duty. Instrument: Make sure the instrument is working properly. Brakes:
Check and make sure the vehicle does not pull to one side during braking on a safe road. Other abnormalities: Check the parts for looseness and leakage, and listen to whether there are unusual noises. 3