BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Driving skills

Driving skills 188 At the early of break-in period, the internal frictional resistance of the engine is much greater than that after the break-in period. All the moving parts of the engine must be run in before achieving the best fit. If the engine has been run in according to the above requirements, its service life can be prolonged and its fuel consumption can be reduced. If new tires and brake pads had not been run in, they would not be pro­ vided with the best adhesion and friction. Be sure to drive carefully during the first 500km to run in the tires well to avoid accidents. You should also follow these rec­ ommendations when the brake pads are replaced.

Keep an appropriate vehicle-to-ve­ hicle distance and try to avoid emergency braking while driving. This is because new tires and brake pads which have not been run in can cause accidents easily. If the brakes are affected with damp or frozen or you drive on salt roads, the braking effect can drop. WARNING Heavy workload can cause your brakes overheat while going down a steep hill. We recommend you slow down by shifting to a lower gear so that you can get extra brak­ ing from the engine to reduce your brakes’ workload. Always apply the brake according to the road and traffic conditions. Avoid unnecessary application of brake pedal.

Doing so can cause brake overheating, resulting in a longer braking distance and exces­ sive wear. Do not coast by turning off your engine. Since the brake booster is disabled, the braking distance will get extended greatly, resulting in accidents. Do not prolong the service time of the brake fluid. Be sure to replace the brake fluid according to the maintenance intervals. WARNING 3 Breaking in tires and brake pads To break in new tires, drive at moderate speeds within the first 500 km. Be sure to break in new brake pads carefully for the first 200 km to achieve the optimal friction state.