Driving skills 189 Driving Tips in Various Conditions Driving in the Rain Before driving, make sure the park ing brake is fully released. Do not put your foot on the brake pedal while driving, otherwise, the brake pad may be overheated and worn, resulting in fuel waste. When driving downhill, slow down the vehicle and shift to a low gear. If you overuse the brakes, they will overheat and not work properly. When driving on a smooth road, be careful when accelerating, upshift ing, downshifting or braking. Sud den acceleration or engine braking can cause wheel slip or wheel spin.
If the brakes are wet, the required braking distance will be longer than normal, and the vehicle may tilt to one side, and the parking brakes will not be able to brake the vehicle firmly. WARNING When driving on slippery roads, In the lateral wind, you must drive at a low speed, so it is easy to control the vehicle. Maintain an appropriate angle to avoid driving at high, sharp-edged objects or other barriers on roads. Failure to do so may cause tire burst and other serious damage. When driving on bumpy roads or rough roads, reduce the speed, otherwise the corresponding impact and scratch will cause serious damage to the vehicle.
Brake may be wet when the vehicle is washed or is running through deep wa ter. Pay attention to the safety around, and then gently press the brake pedal. If there is no brake force, the brake may be wet. To make it dry, drive the vehi cle at low speed while gently pressing the brake pedal when it is safe to do so. Drive your vehicle with care. If the brakes still cannot work properly. Park your vehicle on the roadside and con tact the authorized dealer of BAIC for help. Use caution to drive when it is raining, because the visibility is poor, the windows may become foggy, and the road will be slippery. When it starts to rain, you should drive carefully because the road becomes slippery.
Do not drive at high speed on the road when it rains, because the higher the speed, the easier it is to form a layer of water film between the tire and the road surface, which hinders the normal oper ation of the steering and brake system. Driving on muddy road 3 After the vehicle runs on the mud road, the mud attached to the chassis shall be cleaned in time. Special attention should be paid to the vent plugs of the front and rear axles. If the mud is not cleaned in time, the vent plug cover will be pasted after it is dried, resulting in the failure of the vent plug to open normally for pressure relief, and eventually resulting in the leakage of the drive axle.