BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Spare tire and in-vehicle tool

Spare tire and in-vehicle tool 257 In-vehicle tool Do not use the spare wheel which has been damaged or wears down to the wear indicators. If your spare wheel is over six years old, only use it in emergency with extra care. Check the tire pressure as soon as possible after installing the spare wheels to make it within the speci­ fied range. WARNING 1 2 4. Align the center hole of the replaced Tip wheel with the stud of the spare wheel carrier. 5. First pre-tighten 4 nuts by hand, then The tire pressure of spare wheel is 220kPa.

Tip tighten 3 ordinary wheel nuts with a tightening torque of (110±5) N m, and finally insert the wheel lock button into the wheel lock nut at the correct angle and tighten it with a tightening torque of (50 ±3) N·m. 6. Align the catch of the spare tire wheel The vehicle is equipped with on-vehi­ cle tools located under the rear seats. 5 In-vehicle tools include: 1. Jack 2. On-vehicle tool kit The jack is fixed to the floor of the vehicle by locking bolts, and the on-vehicle tool kit is located behind the jack. cover with the catch of the aluminum wheel, press hard in the axial direction, and press all the six catches in to complete the assembly.