Emergency start 280 Jumper cable 5. Connect one end of the black cable -3- Never charge a frozen battery-explo sion danger! Even if the battery is thawed, the acid solution of the battery may overflow during charging, causing corrosion damage, so the frozen bat tery must be replaced. WARNING When jumpering a battery, the positive terminal must be connected first, and then the negative terminal. to the negative pole (-) of the power supply battery "B", and the other end -4- to the engine block of the depleted battery "A" or the metal part that is fixedly connected to the engine block.. 6.
Start the vehicle with the power supply X 4 battery installed, let it run at idle speed, and then start the engine of the vehicle with the power shortage battery, which needs to run for a period of time, so that the generator can charge the power shortage battery. 7. Remove the cables in the reverse order Attention 1 A When jump starting, protect the dis abled vehicle from contacting the booster vehicle. Otherwise, once the positive poles of the two batteries are connected, the current will be connect ed immediately, which will cause dan ger. 3 2 B of the above. When disassembling, be careful not to be hurt by the rotating belt or fan.
5 Read and follow the relevant warnings before operating the batteries. 1. Wear protective glasses and remove metal accessories such as watches and bracelets to prevent electric shock; 2. Put the start/stop button in the "OFF" position. 3. Connect one end of the red cable -1- to the positive (+) of the dead battery "A". 4. The other end -2- is connected to the positive (+) side of the power supply battery "B".