Emergent traction 281 Emergent traction Place the jumper cables in position to prevent them from touching the moving parts of the engine. When removing the jumper cable, it is necessary to turn on the blower or the rear windshield heater of the vehicle with a dead battery, which can reduce the voltage peak gener ated when removing the cable. In order to ensure successful jump er, the engine should be in idle run ning state during disassembly. Attention A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. WARNING The front and rear of the vehicle are equipped with traction rings for traction.
When your vehicle breaks down or an accident occurs, you can use the front or rear traction rings as traction points to tow your vehicle. The engine compartment is a dan gerous area. Improper operation may cause injuries or deaths. Do not connect the negative cable directly to the negative terminal of the battery without electricity, otherwise sparks will be generated when the cable is connected. The combustible gas produced by the battery may be ignited by sparks, causing explosion accidents. Do not connect the negative cable to the components of the fuel sys tem or the brake pipeline, which may cause fire. Do not lean over the battery during operation to avoid being burned by acid.
Do not touch open flame, otherwise it may cause explosion Attention Towing rings should not be used to tow other vehicles, and should never be used to tow trailers. The best traction method is to use a special tractor. If suspension traction (front wheel lifting) is required or the vehicle must be towed with four wheels on the ground at the same time, attention shall be paid to: When the start / stop button is in the "RUN" position, turn on the hazard warning light. The transmission shift lever shall be placed in neutral or "N" position, and the transfer case shall be placed in 2H position. 5