BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Cabin

Cabin 079 ① On the road with good road conditions, try to drive at a higher gear, and keep the engine speed at about 2000 rpm to keep the speed stable. ② Try to avoid idling the engine. ③ Try to avoid short distance driving and engine stalling. ① Select a flat and safe position for parking, shift the gear to neutral, turn off the engine and apply the parking brake; ② After turning off the engine for 10 minutes, check the oil level.

If the oil level is higher than the upper limit, please stop using it and immediately go to BAIC after- sales service station for treatment; ③ If the liquid level is normal, start the engine and make the engine water temperature reach above 40°C; ④ Wait for more than 1 minute for the engine to be turned off, and press the start/ stop button once to power on the vehicle; ⑤ Press the start/stop button twice in succession to power down the vehicle. The above vehicle power on and power off operations are repeated twice in 15 seconds.

Step down the clutch pedal for the third time, press the start / stop button to start the engine, and release the clutch pedal after starting to restore the pedal to the natural state; If the warning light is on during driving, stop the vehicle immedi­ ately and contact the authorized dealer of BAIC under the condition of ensuring safety. If no measures are taken, serious driving performance problems will occur. WARNING 2 Attention During this procedure, you must com­ ply with all relevant speed limits and laws and regulations, take full account of traffic and weather conditions, and take care of road users when driving. 27.

DPF/GPF (diesel particulate filter/ gasoline particulate filter) indicator light (yellow)* When the engine is in the regeneration state, the indicator light comes on. Automatic regeneration: During driving, when the particulate matter captured in PDF reaches certain conditions, the vehicle will automatically start the regeneration program to fully burn the particulate matter, so that PDF can continue to capture particulate matter. When the vehicle starts the regeneration procedure and enters regeneration, the instrument will light up the DPF regeneration indicator.

In order to facilitate the regeneration process, it is recommended that the customer operate as follows until the indicator goes out: Manual regeneration: I n s o m e s p e c i a l c a s e s , t h e D P F regeneration process is insufficient or frequently interrupted, which will trigger the alarm message. When the DPF indicator light is on and flashing (sometimes accompanied by the engine control system warning light and the engine fault warning light is always on or flashing), it indicates that the DPF needs to perform the manual regeneration procedure immediately. The manual regeneration procedure is as follows: