BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Cabin

Cabin 080 EPB indicator light (green) When the indicator light is on, it indicates that the driver needs to step on the brake pedal to release the electronic hand brake. When this indicator light is on, the alarm pop-up window displays "please step on the brake pedal to release the electronic hand brake". 29. Preheating indicator light (yellow)* When the start/stop button is in the "RUN" position (the engine is not started), the vehicle performs the inspection by itself, and the indicator light goes out soon after being lit.

If the vehicle starts the intake air preheating function (when the ambient temperature is below 20°C or the altitude is above 500 meters), make sure the light is off before starting the vehicle. 30. Oil-water separation indicator light The complete vehicle must be kept parked and the engine is running; Man­ ual gearbox must be placed in neutral; If it is a manual gearbox, do not press the clutch pedal, and the clutch ped­ al remains in a natural state; Do not press the brake pedal; Don't press the accelerator pedal.

Attention This process is called a driving cycle, from pressing the start/stop button once to powering up for more than 20 seconds to pressing the start/stop but­ ton twice to powering down for more than 10 seconds.

When the regenera­ tion process is in progress, please do not carry out any operation, otherwise the regeneration process may exit automatically; If you need to use the vehicle in an emergency, you can exit the program by stepping on the clutch pedal, brake pedal, accelerator, etc., but the fault information will not be eliminated, and it still needs to be dealt with in time; If the engine warning light still does not clear after the regener­ ation procedure is completed and 3 driving cycles, please go to BAIC after sales service station for treatment. Attention 2 ⑥ Start the engine. After about 20 seconds, the DPF can enter the regeneration process.

At this time, the engine speed will automatically rise to about 2000 rpm; ⑦ Wait for 10 to 20 minutes. After the regeneration process is completed, the engine speed will automatically reduce to the idle state, and the DPF regeneration indicator light will go out, indicating that the regeneration is successful. After another 3 driving cycles, the fault is cleared, and the vehicle can be used normally. (red)* This indicator light is always on when the water level in the diesel filter (water in the filtered fuel) exceeds the rated volume. The diesel filter needs to be drained immediately. The diesel filter is arranged on the front panel of the engine compartment.

Gasoline engines are equipped with GPF models. When the particulate filter indicator light is flashing, please go to the nearest BAIC after-sales service station as soon as possible to carry out inspection and operations related to particulate filter regeneration. 28. Press the brake pedal to release the