WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 36 XX — HARDWARE AND SOFTWARE NOT COMPATIBLE Main code 36 indicates the system has detected a mismatch between the ECU hardware and the ECU software or that there is a TransID (TID) problem. A. Active Indicator Clearing Procedure: Power down B. Troubleshooting: 1. Correction for code 36 00 requires the installation of software that is compatible with the ECU hardware involved. (If a different calibration is required, update the ECU hardware to be compatible.) 2. Correction for code 36 01 is to update the ECU calibration. Installation of the latest calibration makes the ECU compatible with the latest TransID configuration. NOTE:
For further information about TransID see Paragraph 1–11 and SIL 7-WT-98. 3. Correction for code 36 02 is to troubleshoot TransID wire 195 and the complete TransID circuit. This code is caused by a short-to-battery of wire 195, but has also been caused by a soft short in the solenoid associated with TransID (B solenoid for TransID 3 units). Rough shifting may accompany the setting of this code since a default calibration value is used instead of the adapted calibration value. Codes 42 XX or 69 XX may be associated with this code. Copyright © 2001 General Motors Corp.
6–59 Main Code Subcode Meaning 36 00 Mismatch between ECU hardware and software 36 01 TransID not compatible with hardware/software 36 02 TransID did not complete