Industrial — CODE 44 XX — SHORT-TO-GROUND IN SOLENOID CIRCUIT

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 44 XX — SHORT-TO-GROUND IN SOLENOID CIRCUIT (Figure 6–16) WT SOLENOID RESISTANCE SPEC VALUE = 3.26 ± .2 OHMS AT 20 ° C 5.2 5 4.8 4.6 SOLENOID RESISTANCE IN OHMS 4.4 4.2 4 MAXIMUM OHMS 3.8 3.6 3.4 MINIMUM OHMS 3.2 2.8 3 2.6 2.4 2.2 4 32 68 104 140 176 212 248 284 SUMP TEMPERATURE IN ° F 2 0 20 40 60 80 100 120 140 SUMP TEMPERATURE IN ° C V00719.01 Figure 6–17. Solenoid Resistance vs. Temperature B. Troubleshooting: 1. Check the transmission connector and make sure it is tightly connected.

If the connector is properly connected, disconnect the harness at the transmission and inspect the terminals in the transmission harness and feedthrough harness connectors. Clean or replace as necessary (Appendix D). 2. If the connector is connected, clean, and not damaged, check the solenoid circuit in the transmission for shorts to other wires. (Tool J 41612 may be useful in making this test.) Refer to the system schematic and/or chart to identify wires in the internal harness which are connected. If the short circuit is found, drain the fluid, remove the control module (refer to the transmission Service Manual), and isolate the short.

The short is probably in the feedthrough harness, or the solenoid itself (refer to Figure 6–1 for solenoid locations). 3. If the short is not found in the transmission, disconnect the transmission harness connector at the ECU and inspect the terminals for damage or contamination. Clean or replace as necessary. If the terminals are satisfactory, check the wires of the solenoid circuit in the transmission harness for shorts-to-ground or shorts between wires. If a short is found in one of the wires, isolate and repair it or use a spare wire, if available, or provide a new wire (St. Clair P/N 200153 may be used for this purpose) in the external harness.

Refer to Appendix E for connector/terminal repair information. 4. If the short is not found in either the transmission or the harness, the condition must be intermittent. 5. Drain the fluid, remove the control module, and closely inspect the solenoid and internal harness for damage. Repair or replace as necessary (refer to the transmission Service Manual). 6–66 Copyright © 2001 General Motors Corp.