WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 45 XX — OPEN CONDITION IN SOLENOID CIRCUIT (Figure 6–18) Main code 45 indicates the ECU has detected either an open circuit condition in a solenoid coil or the wiring to that solenoid. The DO NOT SHIFT response is activated when some subcodes are detected, all solenoids are turned off, and the CHECK TRANS light is illuminated. A. Active Indicator Clearing Procedure: Power down Manual NOTE: Intermittent connections or lack of battery-direct power and ground connections may cause this and other codes. NOTE: Before troubleshooting, read Paragraph 6–6. Also, check battery and ECU input voltages.
PROBING THE CONNECTOR When testing the control module solenoids from the feedthrough connector with the internal harness connected, the resistance of each solenoid can be checked using a VOM. Refer to Figure 6–19 for solenoid resistance values versus temperature. Copyright © 2001 General Motors Corp.
6–69 Main Code Subcode Meaning 45 12 Open Circuit A Solenoid Circuit 45 13 Open Circuit B Solenoid Circuit 45 14 Open Circuit C Solenoid Circuit 45 15 Open Circuit D Solenoid Circuit 45 16 Open Circuit E Solenoid Circuit 45 21 Open Circuit F Solenoid Circuit 45 22 Open Circuit G Solenoid Circuit 45 23 Open Circuit H Solenoid Circuit 45 24 Open Circuit J Solenoid Circuit 45 26 Open Circuit N Solenoid Circuit