Industrial — CODE 52 XX — OFFGOING C3 PRESSURE SWITCH TEST DURING SHIFT

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 52 XX — OFFGOING C3 PRESSURE SWITCH TEST DURING SHIFT Main code 52 indicates a failed C3 pressure switch test. When a shift is commanded and C3 is the offgoing clutch, the ECU expects the C3 pressure switch to open within a period of time after the shift is commanded. If the ECU does not see the switch open, it assumes C3 has not released. If conditions for a shift exist, the shift is retried. If the C3 pressure switch still remains closed, the code is logged and the DO NOT SHIFT response is commanded.

If the code is set during a direction change, neutral with no clutches is commanded, otherwise the transmission is commanded to the previous range. Additional codes could be logged for other shifts where “X” indicates the range from and “Y” indicates the range to. NOTE: C3 tests are turned off below a calibrated temperature of –32єC (–25˚F). A. Active Indicator Clearing Procedure: Power down Manual NOTE: Before troubleshooting, read Paragraph 6–6. Also, check battery and ECU input voltages. NOTE: Intermittent connections or lack of battery-direct power and ground connections may cause this and other codes. B. Troubleshooting: 1.

Use the ATDT TM or Pro-Link ® diagnostic tool to check the state of the C3 pressure switch. 2. Check the C3 pressure switch wiring for a short-to-ground or a switch stuck closed (refer to code 32 XX). If a short is found, isolate and repair; or replace the switch if it is stuck closed. 3. If a fault is not found with the C3 pressure switch or circuitry, connect a pressure gauge to the C3 pressure tap. 4. Drive the vehicle to make the shift indicated by the subcode or use the DDR clutch test mode. Compare actual C3 pressure value with the table of specifications in Appendix B. 5.

If C3 is being held on hydraulically (C3 remains pressurized), drain the fluid, remove the control module, disassemble and clean the control module, checking for damaged valve body gaskets or stuck and sticky valves (see the transmission Service Manual). 6–76 Copyright © 2001 General Motors Corp. Main Code Subcode Meaning 52 01 L–1 upshift 52 08 L–N1 shift 52 32 3–2 downshift 52 34 3–4 upshift 52 54 5–4 downshift 52 56 5–6 upshift 52 71 R–1 shift 52 72 R–2 shift 52 78 R–N1 shift 52 99 N3–N2 shift 52 XY X–Y shift