WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 51 XX — OFFGOING RATIO TEST DURING SHIFT (TIE-UP TEST) Copyright © 2001 General Motors Corp. 6–75 2. If the fluid level is correct, connect a pressure gauge into the pressure tap for the offgoing clutch indicated by the code (refer to solenoid and clutch chart, Appendix C). Make the shift indicated by the subcode or use the ATDTTM or Pro-Link® diagnostic tool clutch test mode to put the transmis- sion in the off-going and oncoming ranges (refer to Appendix B for clutch pressure check informa- tion). 3.
If the offgoing clutch stays pressurized, drain the fluid, remove the control module, disassemble the control module and clean it, inspecting for damaged valve body gaskets and stuck or sticky valves. Inspect the transmission for signs of clutch damage indicating the need to remove and overhaul the transmission (refer to the transmission Service Manual). 4. If the problem has not been isolated, replace the solenoid for the offgoing clutch (refer to the transmission Service Manual). CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage.
Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle. This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle. Transmission performance could be worse and damage to the clutches may occur. NOTE: If using an ECU from another vehicle is unavoidable, the ECU must be set to unadapted shifts and the vehicle must be driven carefully to adapt the shifts to the test vehicle. Refer to Service Information Letter 16-WT-96 for the correct procedure.
Be sure to reset the ECU to unadapted shifts when it is returned to the original vehicle. 5. If the condition persists, replace the ECU with a test diagnostic ECU (P/N must match and it is recommended that the controller be loaded with the latest version of the CIN). If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU. If the original ECU now works, inspect the ECU connectors for corrosion or damage which may cause an intermittent condition. If the original problem recurs, install a replacement ECU.