Industrial — CODE 54 XX — ONCOMING SPEED TEST (AFTER SHIFT)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 54 XX — ONCOMING SPEED TEST (AFTER SHIFT) 6–82 Copyright © 2001 General Motors Corp. use a twisted-pair for a new speed sensor circuit — Service Harness Twisted Pair P/N 200153 is available from St. Clair Technologies for this purpose. CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage. Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle.

This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle. Transmission performance could be worse and damage to the clutches may occur. NOTE: If using an ECU from another vehicle is unavoidable, the ECU must be set to unadapted shifts and the vehicle must be driven carefully to adapt the shifts to the test vehicle. Refer to Service Information Letter 16-WT-96 for the correct procedure. Be sure to reset the ECU to unadapted shifts when it is returned to the original vehicle. 9.

If the condition persists, replace the ECU with a test diagnostic ECU (P/N must match and it is recommended that the controller be loaded with the latest version of the CIN). If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU. If the original ECU now works, inspect the ECU connectors for corrosion or damage which may cause an intermittent condition. If the original problem recurs, install a replacement ECU.