WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 55 XX — ONCOMING C3 PRESSURE SWITCH (AFTER SHIFT) Main code 55 indicates the C3 clutch is the oncoming clutch in a shift and the C3 pressure switch did not close at the end of the shift. When this code is set, the DO NOT SHIFT response and Neutral with No Clutches is commanded. On the N1 to R shift the transmission is commanded to the previous range. Additional codes could be logged for other shifts where “X” indicates the range from and “Y” indicates the range to. NOTE: When an ECU with a version 8, 8A, 9, or 9A calibration is used with a pre-TransID transmission, 55 XX codes are set because the ECU sees wire 195 is open.
To correct this condition, convert to a TID 1 internal harness or install Adapter P/N 200100 available from St. Clair Technologies. Further TransID (TID) information is in Paragraph 1–11. *NOTE: When sump temperature is below 10˚C (50˚F), and transmission fluid is C4 (not DEXRON ® ), follow this procedure when making directional change shifts: To shift from forward to reverse; select N (Neutral) and then R (Reverse). Failure to follow this procedure may cause illumination of the CHECK TRANS light and then transmission operation will be restricted to N (Neutral). A. Active Indicator Clearing Procedure: Power down Manual — subcode 87 only NOTE:
Intermittent connections or lack of battery-direct power and ground connections may cause this and other codes. NOTE: Check battery and ECU input voltages before troubleshooting. B. Troubleshooting: NOTE: Do not bring the transmission to operating temperature if the problem occurs at sump temperatures below that level. Do troubleshooting at the temperature level where the problem occurs. 1. After the transmission is at operating temperature, allow vehicle engine to idle on level ground for 3–4 minutes. Check transmission fluid level. If improper fluid level is found, correct as necessary.
Improper fluid level could be the cause of the code (not enough or too much fluid may produce inadequate clutch pressure). 2. Connect a pressure gauge and check main pressure. If pressure is not adequate, the pump is possibly worn. See Appendix B for main pressure specifications. Copyright © 2001 General Motors Corp. 6–83 Main Code Subcode Meaning 55 07* Oncoming C3PS (after shift), L–R shift 55 17* Oncoming C3PS (after shift), 1–R shift 55 27* Oncoming C3PS (after shift), 2–R shift 55 87 Oncoming C3PS (after shift), N1–R shift 55 97 Oncoming C3PS (after shift), N1–L to R shift 55 XY Oncoming C3PS (after shift), X to Y shift