WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 62 XX — RETARDER TEMPERATURE SENSOR (Figure 6–22) NOTE: When an ECU with a version 8 (CIN 0A...) calibration is used with a TransID 2 transmission, 62 XX codes are set because the ECU does not have the proper calibrations for the TID 2 thermistors. The ECU calibration must be updated to version 8A (CIN 0B...). TransID (TID) information related to thermistor changes is in Paragraph 1–11 and detailed troubleshooting information for TID 2 thermistors is shown in Appendix Q. Main code 62 indicates the retarder temperature sensor or engine coolant sensor or circuitry is providing a signal outside the usable range of the ECU.
Main code 62 can be the result of a hardware failure or an actual extremely high or low temperature condition. A. Active Indicator Clearing Procedure: Power down Manual Self-clearing — subcodes 32 and 33 NOTE: Before troubleshooting, read Paragraph 6–6. Also, check the transmission fluid level. B. Troubleshooting: NOTE: A combination of codes 62 23, 33 23, and 21 23 indicates a problem with one of the branches of the common ground wire (wire 135) between the throttle and temperature sensors. NOTE: Code 62 12 can be caused when the +5V power line (wire 124) is shorted to ground or open.
Wire 124 also provides power for the OLS, TPS, RMR, sump temperature sensor, and shift selectors and is present in all three ECU connectors. 1. Check the retarder temperature or engine coolant temperature with a DDR. If a DDR is not available, use the shift selector display to determine if the code is active (cycle the ignition on and off at least once since the code was logged to clear the code’s active indicator). If a condition that is unreasonable for the current conditions exists, go to Step (3). 2. If Step (1) reveals that the extreme temperature indication is no longer present, the temperature limit could have been reached due to operational or ambient temperature extremes.
Proceed cautiously as it is unlikely there is a sensor hardware fault. 3. Remove the connector at the ECU. Measure resistance between harness terminals T25 and T28 or between harness terminals V9 and V24. Compare resistance value to chart (see Figure 6–21) to see if reading is within expected operating range. 4. Disconnect the sensor connector and remove the connector at the ECU. Check the sensor and the ECU terminals for dirt, corrosion, and damage. Clean or replace as necessary (refer to Appendix E). Copyright © 2001 General Motors Corp.
6–91 Main Code Subcode Meaning 62 12 Retarder temperature sensor failed low (–45˚C; –49˚F) 62 23 Retarder temperature sensor failed high (178˚C; 352˚F) 62 32 Engine coolant sensor failed low 62 33 Engine coolant sensor failed high