WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 62 XX — RETARDER TEMPERATURE SENSOR (Figure 6–22) 6–92 Copyright © 2001 General Motors Corp. 5. Check the temperature sensor circuit for opens (code 62 23 or 62 33), shorts between wires, and short-to-ground (code 62 12 or 62 32). If a wiring problem is found, isolate and repair. See Appendix E for connector service information. 6. If no wiring problem is found, replace the retarder or engine coolant temperature sensor (refer to transmission or vehicle Service Manual for proper procedure). 7. If the problem recurs, use a spare wire, if available, or provide a new wire (St.
Clair P/N 200153 may be used for this purpose) for the retarder or engine coolant temperature circuit. See Appendix E for connector service information. CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage. Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle. This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle. Transmission performance could be worse and damage to the clutches may occur. NOTE:
If using an ECU from another vehicle is unavoidable, the ECU must be set to unadapted shifts and the vehicle must be driven carefully to adapt the shifts to the test vehicle. Refer to Service Information Letter 16-WT-96 for the correct procedure. Be sure to reset the ECU to unadapted shifts when it is returned to the original vehicle. 8. If the condition persists, replace the ECU with a test diagnostic ECU (P/N must match and it is recommended that the controller be loaded with the latest version of the CIN). If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU.
If the original ECU now works, inspect the ECU connectors for corrosion or damage which may cause an intermittent condition. If the original problem recurs, install a replacement ECU.