WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 66 XX — SCI (SERIAL COMMUNICATION INTERFACE) FAULT (Figure 6–24) The datalink for throttle sensor or engine coolant temperature must have been recognized by autodetect or manually selected using the ATDT TM or Pro-Link ® (see ATDT User Guide GN3433EN or WTEC III Pro-Link ® Manual) before these codes can be logged. See Paragraphs 1–9 or 1–10 for further information. Main code 66 indicates the ECU is expecting to get its throttle position signal or engine coolant signal across a serial communication interface from a computer-controlled engine.
Either the engine computer is not sending the throttle or engine coolant information or the wiring between the engine and transmission computers has failed. Code 66 00 can occur when the transmission ECU remains powered when the engine ECM is powered down. The transmission sees this as a communication link failure. A. Active Indicator Clearing Procedure: Power down — subcodes 00, 11, and 22 Manual Self-clearing — subcodes 00, 11, and 33 B. Troubleshooting: 1. Check for a throttle signal or engine coolant signal from the engine to the transmission, an engine computer malfunction, an engine throttle fault, or an engine coolant fault. NOTE:
Throttle position data sent from a computer-controlled engine may register a low number of counts on the DDR, but the counts will not change as throttle percentage is changed. 2. Check wires 142 and 151 between the engine and transmission ECU for an open or short. Check that all connectors are clean and tightly connected. NOTE: These codes can also be set if J1939 communications fail. Check wires 183-S13, 184-S29, and 182-S12 for opens or shorts. 3. Use the ATDT TM or Pro-Link ® to see if the ECU is receiving power when it should not. 4. Code 66 22 This code is set when J1939 communication is incorrect or interrupted. Find the cause for the communication problem. 5.
Code 66 33 This code is set when Driver Demand Torque is not being received from the engine. This code indicates a problem with either the CAN link or the engine. Troubleshoot the wiring described in the NOTE following Step 2 above. If wiring checks okay, go to vehicle or engine OEM for engine controls check. 6. Code 66 34 This code indicates the engine is communicating but is not responding to torque reduction commands. Troubleshoot as if code 66 00 is active. If no transmission problems were found, go to vehicle or engine OEM for engine controls check. Copyright © 2001 General Motors Corp.
6–101 Main Code Subcode Meaning 66 00 SCI (Serial Communication Interface) fault 66 11 SCI Engine coolant source fault 66 22 J1939 Retarder request fault 66 33 J1939 Driver demand torque fault 66 34 Engine not responding to J1939 SEM control