Industrial — CODE 69 XX — ECU MALFUNCTION

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 69 XX — ECU MALFUNCTION Main code 69 indicates a problem which has been identified as being from within the ECU. A “cateye” display or a blank display may occur with subcode 33. A. Active Indicator Clearing Procedure: Power down Manual — subcodes 27, 28, 29, and 39 Self-clearing — subcode 42 and subcodes 33, 35, 36, and 41; after an ECU reset NOTE: Subcode 34 cannot be cleared. B. Troubleshooting: 1. For subcodes 27, 28, and 29, check for shorts to battery before replacing the ECU. Follow the troubleshooting steps for code 42 XX for checking shorts to battery. If no shorts are found, replace the ECU.

If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU. If the problem recurs, reinstall the new ECU to complete the repair. 2. For all other subcodes, replace the ECU. 6–102 Copyright © 2001 General Motors Corp. Main Code Subcode Meaning 69 27 ECU, Inoperative A-Hi switch 69 28 ECU, Inoperative F-Hi switch 69 29 ECU, Inoperative N-Hi and H-Hi switch 69 33 ECU, computer operating properly timeout 69 34 ECU, EEPROM write timeout 69 35 ECU, EEPROM checksum 69 36 ECU, RAM self-check failure 69 39 Communication chip addressing error 69 41 ECU, I/O ASIC addressing test 69 42 SPI output failure 69 43 SPI input failure