WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. Table 8–1.
Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy TRANSMISSION WILL NOT SHIFT TO FORWARD OR REVERSE (STAYS IN NEUTRAL) Engine rpm too high Reduce engine rpm (it may be necessary to reselect Neutral also, and then D or R) Low fluid level Add fluid to proper level (refer to transmission Mechanic’s Tips for proper dipstick calibration) Throttle position sensor or linkage is not functioning properly Refer to throttle position sensor for correct set-up (Appendix F) Voltage to ECU too low Check vehicle battery and charging system Shift selector is not functioning properly Replace shift selector Disconnected or dirty connectors Perform connector checkout (Appendix E) Faulty wiring harnesses Repair harness (Appendix E) Speed sensor(s) not functioning properly Repair or replace speed sensor(s) or circuitry (see transmission Service Manual and Appendix E) Faulty ECU Replace the ECU Input function wire open and auxiliary function range inhibit in the calibration Check input function programming with ATDTTM or Pro-Link®.
Correct wiring or switch problem which does not allow input function wire to be grounded. Auxiliary Function Range Inhibit-Standard — hooked up to brake pressure Apply brakes with high force TRANSMISSION WILL NOT STAY IN FORWARD OR REVERSE Auto-neutral or quick-to-neutral circuit (input function) faulty Repair quick-to-neutral circuit Leaking at solenoid assembly Rebuild solenoid assembly (see transmission Service Manual) Faulty solenoid — leaking Replace solenoid (see transmission Service Manual)