Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. Table 8–1.

Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy TRANSMISSION WILL NOT MAKE A SPECIFIC SHIFT Low engine power Correct engine problem, see Engine Service Manual Incorrect fluid level Correct fluid level (refer to transmission Mechanic’s Tips for proper dipstick calibration) Extreme fluid temperature Inspect cooling system and fluid level Faulty speed sensor/circuit Repair circuit or replace speed sensor(s) (see code 22 XX) Faulty temperature sensor/circuit Check for temperature reading which inhibits shifts Incorrect calibration Install proper calibration Faulty shift selector Replace shift selector Hydraulic problem Refer to Range Clutch Troubleshooting section Faulty ECU Replace ECU TRANSMISSION LOCKUP CLUTCH WILL NOT ENGAGE ABS fault active Correct ABS fault.

Upgrade software to S02 or later.

TRANSMISSION DOES NOT SHIFT PROPERLY (ROUGH SHIFTS, SHIFTS OCCURRING AT TOO LOW OR TOO HIGH SPEED) Engine idle speed too fast (neutral to range shift) Adjust engine idle speed (refer to Vehicle Service Manual) Faulty throttle sensor/circuit Refer to throttle sensor section for installation and operation information (Appendix F) ECU input voltage low Check power, ground, charging system, and battery function Incorrect shift calibration for vehicle Install correct calibration Instrument panel tachometer incorrect Repair or replace tachometer Incorrectly calibrated electronic speedometer Calibrate electronic speedometer Faulty speed sensor/circuit Repair circuit or replace speed sensor (see code 22 XX) Loose speed sensor Tighten speed sensor retaining bracket bolt