WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. Table 8–1.
Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy TRANSMISSION DOES NOT SHIFT PROPERLY (ROUGH SHIFTS, SHIFTS OCCURRING AT TOO LOW OR TOO HIGH SPEED) (cont’d) Incorrect fluid level Correct fluid level (refer to Mechanic’s Tips for proper dipstick calibration) Crossed wires in harness Check for crossed wires and correct Intermittent problems Check wiring harnesses and connectors (Appendix E) Loose or damaged speed gear Replace output bearing nut sensor retainer Control spool valve sticking Overhaul valve body assembly (refer to transmission Service Manual) Sticking stage 2 solenoid valve Overhaul valve body assembly (refer to transmission Service Manual) Incorrect calibration Install correct calibration CRUISE CONTROL COMPLAINTS A.
Cruise Control Shift Cycles Performance shift schedule is being used. Switch to economy shift schedule. Incorrect droop settings Modify engine droop settings to provide a larger speed variation before reaction occurs (CAT engines should be set on “soft cruise”. Cummins engines droop settings should be +2 mph and -3 mph.) Cruise Control calibration not present in Version 9 software Update ECU software from V9 to V9A which has the cruise control shift schedule. RETARDER PERFORMANCE COMPLAINTS A. Retarder Does Not Apply Retarder enable input not activated Turn on retarder enable switch (if present). Retarder enable switch not working Replace retarder enable switch (if present).
ABS input is active (if vehicle is equipped with ABS) None — This is normal. If ABS is active, retarder will not apply.