WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. Table 8–1. Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy A. Retarder Does Not Apply (cont’d) Retarder Request below 10.2 percent Use DDR to determine counts signaled by each RMR device present. At least 15 counts are required for some retarder apply and 150–232 counts are required for full apply. Replace RMR device, based on test results. Closed throttle not sensed Use DDR to check throttle signal. Throttle must be below 9.8 percent before retarder will apply. Readjust or replace TPS. Exception:
If TPS has failed and Service Brake Status input is sensed by ECU, the retarder will still be applied. Active code inhibiting retarder Correct cause for setting these codes: 42 23, 44 23, 45 23, 46 26, 64 12, 64 23, or 69 29 Transmission output speed below 350 rpm (450 rpm for HD/B 500) Raise output speed to above 350 rpm (450 rpm for HD/B 500) Transmission not in a forward range Shift to a forward range B. Reduced Retarder Effect Retarder accumulator solenoid not being energized Correct cause for setting these codes: 42 26, 44 26, 45 26, or 69 26. ECU sensing false overheat condition Use DDR or VOM to check retarder temperature sensor. Replace sensor as required.
Normal response to overheating See Table 6–7 in Section 6 (Code 61) C. Less Retarder Effect Than Expected Transmission fluid aerated due to incorrect level Check transmission fluid level and correct as required. Wrong retarder control regulator valve spring Check retarder charging pressure. Change retarder control valve regulator spring, if necessary. See SA2831 WT Series Retarder Principles of Operation.