WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS * See explanation of NVL in Section 2–3. Copyright © 2001 General Motors Corp. Table 8–1. Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy ABNORMAL ACTIVITIES OR RESPONSES A. Excessive Creep in First and Reverse Gears Engine idle speed too high Adjust to correct idle speed — between 500–800 rpm (refer to Vehicle Service Manual) B. No Response to Shift Selector Shift selector not properly connected Check shift selector response with diagnostic tool.
If no response, check remote connection and replace if necessary Using wrong selector on dual station equipment Use other selector Faulty shift selector Replace shift selector Incorrect fluid level Correct fluid level (refer to transmission Mechanic’s Tips for proper dipstick calibration) Main pressure low Refer to Low Pressure section Control spool valves sticking (C1, C3, or C5 clutch pressure low) Overhaul valve body assembly (refer to transmission Service Manual) C. Vehicle Moves Forward in Neutral* C1 clutch failed or not released Rebuild C1 clutch (refer to transmission Service Manual) D.
Vehicle Moves Backward in Neutral* C3 clutch failed or not released Rebuild C3 clutch assembly (refer to transmission Service Manual) EXCESSIVE FLARE — ENGINE OVERSPEED ON FULL-THROTTLE UPSHIFTS TPS Adjustment: — Overstroke — Adjust TPS linkage for proper stroke (see Appendix F) — Loose — Tighten loose bolts or connections Incorrect calibration Correct calibration ECU input voltage low Check electrical system and all connections from battery and ECU Incorrect fluid level Add fluid to proper level (refer to transmission Mechanic’s Tips for proper dipstick calibration)