Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS * See Appendix B — Check main pressure, clutch pressure, and pressure specifications. Copyright © 2001 General Motors Corp. Table 8–1.

Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy EXCESSIVE FLARE — ENGINE OVERSPEED ON FULL-THROTTLE UPSHIFTS (cont’d) Low main pressure See Low Pressure section Erratic speed sensor signal See code 22 XX Sticking stage 2 solenoid valve (see Solenoid and Clutch sections) Clean and repair stage 2 valve (refer to transmission Service Manual) Piston seals leaking or clutch plates slipping in range involved (see Range Clutch Troubleshooting section) Overhaul transmission (refer to transmission Service Manual) RANGE CLUTCH TROUBLESHOOTING SECTION EXCESSIVE SLIPPAGE AND CLUTCH CHATTER Incorrect calibration Verify calibration ECU input voltage low Check power, ground, charging system, and battery functions Throttle position sensor out of adjustment or failed Adjust or replace throttle position sensor (refer to Appendix F) Incorrect speed sensor readings See code 22 XX Incorrect fluid level Correct fluid level (refer to Mechanic’s Tips for proper dipstick calibration measurements) Main pressure low Refer to the Low Pressure section Lockup clutch not applied Inspect lockup clutch system wiring, pressure, and controls; repair as necessary (refer to transmission Service Manual)* A.

Ranges 1, 2, 3, 4 Only (6-Speed) Ranges 2, 3, 4, 5 only (7-Speed) C1 clutch slipping, leaks at splitline gasket, leaks at rotating clutch seals, leaks at piston seals, C1 clutch plates worn Inspect control module gasket, C1 clutch plates, and piston and rotating seals; replace/rebuild as necessary (refer to transmission Service Manual)* B. Ranges 4, 5, 6 Only (6-Speed) Ranges 5, 6, 7 only (7-Speed) C2 clutch slipping, leaks at splitline gasket, leaks at rotating clutch seals, leaks at piston seals, C2 clutch plates worn Inspect control module gasket, C2 clutch plates, and piston and rotating seals; replace/rebuild as necessary (refer to transmission Service Manual)*