Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS * See Appendix B — Check main pressure, clutch pressure, and pressure specifications. 8–10 Copyright © 2001 General Motors Corp. Table 8–1. Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy C. Ranges 3, 5, R Only (6-Speed) Ranges 1, 4, 6, R only (7-Speed) C3 clutch slipping, leaks at face seals, leaks at piston seals, C3 clutch plates worn Inspect control module face seals, C3 clutch plates, and piston seals; replace/rebuild as necessary (refer to transmission Service Manual)* D.

Ranges 2, 6 Only (6-Speed) Ranges 3, 7 only (7-Speed) C4 clutch slipping, leaks at face seals, leaks at piston seals, C4 clutch plates worn Inspect control module face seals, C4 clutch plates, and piston seals; replace/rebuild as necessary (refer to transmission Service Manual)* E. Ranges 1, R Only (6-Speed) Ranges 2, R only (7-Speed) C5 clutch slipping, leaks at face seals, leaks at piston seals, C5 clutch plates worn Inspect control module face seals, C5 clutch plates, and piston seals; replace/rebuild as necessary (refer to transmission Service Manual)* F.

Range Lo Only (7-Speed) C6 clutch slipping, leaks at splitline gasket(s), leaks at piston seals, C6 clutch plates worn Inspect control module gasket, adapter gasket, T-Case gasket(s) C6 clutch plates, and piston seals; replace/rebuild as necessary (refer to transmission Service Manual)* LOW PRESSURE SECTION A.

Low Main Pressure in All Ranges (Including C6, T-Case) Incorrect fluid level Correct fluid level (refer to the Mechanic’s Tips Handbook for correct dipstick calibration)* Oil filter element clogged or faulty Replace oil filter (refer to transmission Mechanic’s Tips) Plugged or faulty suction filter Clean or replace oil suction filter element and refill the transmission (refer to transmission Mechanic’s Tips) Main pressure regulator valve sticking Overhaul control module assembly (refer to transmission Service Manual) Main pressure regulator valve spring weak, broken, or missing Check spring and replace if necessary (refer to transmission Service Manual) Control module body leakage (separator plate not flat, separator plate gasket leakage, loose control valve body bolts) Replace or rebuild control module assembly.

Care should be taken when removing and labeling shift springs (refer to transmission Service Manual)