WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. 8–11 Table 8–1. Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy A. Low Main Pressure in All Ranges (Including C6, T-Case) (cont’d) Faulty or incorrect fluid pressure gauge Repair or replace gauge Oil pump worn or damaged Replace or rebuild oil pump (refer to transmission Service Manual) B. Clutch Pressure Low in Specific Ranges, Normal Pressure in Other Ranges See Range Clutch Troubleshooting section and Appendix B C.
Low Lubrication Pressure Incorrect fluid level Correct fluid level (refer to the Mechanic’s Tips Handbook for proper dipstick calibration) Plugged lube filter Change filter (refer to Transmission Mechanic’s Tips) Excessive internal fluid leakage Check other pressures (above items); also check control module mounting bolts; lubrication valve and spring (refer to transmission Service Manual) Broken or damaged converter regulator retaining pin Replace damaged or broken parts (refer to transmission Service Manual) Cooler lines restricted or leaking Check for kinks, leakage; reroute or replace lines as necessary Lubrication valve sticking Replace lubrication valve Cooler plugged Clean or replace cooler Faulty gauge Repair or replace gauge ABNORMAL STALL SPEEDS (Stall In First Range — 6-Speed) (Stall In Second Range — 7-Speed) A.
High Stall Speeds Not in gear Select D (Drive) Low fluid level, aerated fluid Add fluid to proper level (refer to Mechanic’s Tips for proper dipstick calibration) Incorrect torque converter Replace torque converter (refer to transmission Service Manual) Clutch pressure low Refer to Low Pressure section and Appendix B