Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. 8–13 Table 8–1.

Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy OVERHEATING IN ALL RANGES (cont’d) Cooler flow loss due to internal leakage Overhaul transmission (refer to transmission Service Manual) Inadequate cooler sizing See vehicle OEM for specifications Excessive cooler circuit pressure drop Check for plugged cooler, lines too small, collapsed hose, too many elbows in circuit FLUID COMES OUT OF THE FLUID FILL TUBE AND/OR BREATHER Dipstick loose Tighten cap, replace if necessary Fluid level too high Drain to proper level (refer to transmission Mechanic’s Tips) Fluid level too low Add fluid to proper level Breather stopped up — clogged Clean or replace breather (refer to transmission Service Manual) Fluid contaminated with foreign liquid Drain and replace fluid.

Locate and fix source of additional fluid (refer to transmission Service Manual if repair is needed) Dipstick or fill tube seal worn Replace seals or dipstick Incorrect dipstick marking Calibrate dipstick (refer to transmission Mechanic’s Tips) NOISE OCCURRING INTERMITTENTLY (BUZZING) Low fluid level Add fluid to proper level (refer to transmission Mechanic’s Tips for proper dipstick calibration) Air leak in oil suction screen canister Replace oil suction screen canister (refer to transmission Service Manual) Clogged filters Replace filters (refer to transmission Mechanic’s Tips) Aerated fluid causes noisy pump Correct fluid level (refer to transmission Mechanic’s Tips for proper dipstick calibration) Low main pressure causes main regulator valve to oscillate See Low Pressure section