Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS 8–14 Copyright © 2001 General Motors Corp. Table 8–1.

Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy LEAKING FLUID (OUTPUT SHAFT) Faulty or missing seal at output flange Install new lip-type seal in rear of transmission housing (refer to transmission Service Manual) Machine lead on output flange seal surface Replace flange Flange worn at seal surface Replace flange Insufficient seal around seal OD When replacing seal, apply sealant (refer to transmission Service Manual) Damaged, missing, or loose output flange bolts Replace and/or torque output flange bolts Damaged or missing flange button O-ring Replace flange button O-ring Damaged or missing bolt O-rings Replace O-rings TRANSMISSION INPUT Front seal leaks Replace front seal (refer to transmission Service Manual) Converter leaks Check converter seals, cracked converter pump tangs, converter cover, or converter housing porosity; replace parts as required (refer to transmission Service Manual) PTO driveline out of specification Bring driveline into specification DIRTY FLUID Failure to change fluid and filters Change fluid and install new filters (refer to transmission Mechanic’s Tips) Excessive heat Refer to Overheating section Damaged fluid filter/seals Replace oil filter/seals (refer to transmission Mechanic’s Tips) Substandard fluid Use recommended fluid (refer to transmission Mechanic’s Tips) Clutch/transmission failure Overhaul transmission (refer to transmission Service Manual)