WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS * Contact your nearest Allison dealer/distributor with specific questions relating to PTO repair. Copyright © 2001 General Motors Corp. 8–15 Table 8–1. Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy POWER TAKEOFF (PTO)* A.
Leaks Damaged or cocked seal Replace seal PTO flange grooved at seal Replace PTO flange Loose flange Inspect flange and bolts; replace if necessary and properly torque bolts Loose bolts or damaged gaskets Replace gasket and/or properly torque bolts Loose or damaged hydraulic lines (clutched drive) Tighten fittings (replace if necessary) B. Noisy PTO Faulty driven component Replace faulty driven component Gears or bearings worn, damaged, or contaminated Rebuild PTO with new gears or bearings C.
No or Intermittent Operation (Clutched Drive) Electrical problem (switch, connectors, solenoid, or wires) Inspect for electrical problem and repair (see Appendix E) Damaged or worn clutch Rebuild clutch assembly Clutch piston seals damaged or missing Rebuild clutch assembly Inadequate fluid pressure to PTO Inspect and repair fluid pressure supply; line kinked, loose, or plugged; orifice too small Engine speed outside operating band Increase or reduce engine speed to move within operating band Drive or driven gear teeth damaged Replace damaged gears (refer to transmission Service Manual) TRANSFER CASE (T-CASE) A.
Will Not Go Into First Range TPS adjustment Properly adjust TPS (refer to Appendix F) Engine speed too high Reduce Engine Speed Wrong calibration Calibrate properly Wrong control module (6 speed instead of 7 speed) Install correct control module