Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS 8–16 Copyright © 2001 General Motors Corp. Table 8–1. Troubleshooting Performance Complaints (cont’d) Problem Probable Cause Suggested Remedy A. Will Not Go Into First Range (cont’d) Faulty wiring, solenoid connectors Check wiring and connectors in control module (refer to transmission Service Manual) Faulty C6 seals Replace C6 piston seals (refer to transmission Service Manual) Worn C6 clutch plates Rebuild C6 (refer to transmission Service Manual) B. Makes Excessive Noise Improperly shimmed bearings Check all T-case bearings as directed in transmission repair manual. Reshim as necessary.

C. No Front Output Drive Differential clutch bad (C7 piston seals, C7 rotating seals, C7 clutch plates, C7 check ball) Rebuild differential clutch (refer to transmission Service Manual) C7 electrical (wires, solenoids, terminals, connectors) Inspect and repair C7 electrical system (refer to Appendix E) D. Transmission Fluid Leaks Damaged output seal, output flange seal journal, gasketed mating surfaces, bearing endcaps, electrical connector, oil scavenge line Determine source of leak and repair (refer to transmission Service Manual)