Industrial — 1–2. DELPHI-PACKARD METRI-PACK 150 SERIES CONNECTORS — PULL-TO-SEAT (SPEED SENSOR; ACCUMULATOR S...

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–2. DELPHI-PACKARD METRI-PACK 150 SERIES CONNECTORS — PULL- TO-SEAT (SPEED SENSOR; ACCUMULATOR SOLENOID; 30-WAY AND 18-WAY VIM) A.

Connector/Terminal Repairs Wire Stripper Crimping Tool Wire Crimp Insulation Crimp Alternate Crimping Tool Remover Tool J 35615 J 38125-7 Anvil “E” Anvil “C” J 35123 J 35689-A Use Description Manufacturers P/N Turbine Speed (Nt) Sensor (MD/B 300/B 400) Connector Terminal 12162723 12110236 Turbine Speed (Nt) Sensor (HD/B 500) Connector Terminal 12162193 12103881 Engine/Output (All Models) (Ne/No) Speed Sensor Connector Terminal 12162193 12103881 Accumulator (N Solenoid) And Retarder (H Solenoid For TID 2) Connector Terminal 12162197 12103881 Vehicle Interface Module (VIM) Connector (VIM) Connector Body 9-Way Seal (x2) 18-Way Strain Relief Special Bolt Bolt Retainer Sealing Plug Terminal 12040920 12040936 12110545 12129426 12034236 12034413 12103881 Vehicle Interface Module (Vehicle) Connector (OEM) Connector Body 15-Way Seal (x2) 30-Way Strain Relief Special Bolt Bolt Retainer Sealing Plug Terminal 12034397 12040879 12110546 12129426 12034236 12034413 12103881 B.

Terminal Removal NOTE: Do not solder crimps. 1. Insert needle end of terminal remover J 35689-A into the small notch between the connector and the terminal to be removed (Figure E–2, View A). Push the lock tang toward the terminal. 2. Push the wire and terminal out of the connector (this is a “pull-to-seat” terminal). Copyright © 2001 General Motors Corp.