Industrial — 1–2. DELPHI-PACKARD METRI-PACK 150 SERIES CONNECTORS — PULL-TO-SEAT (SPEED SENSOR; ACCUMULATOR S...

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS B. Terminal Removal (cont’d) 3. Pull terminal as far as necessary from the connector. This will be limited by the number of other wires inserted into the connector and by the distance between the back side of the connector and the beginning of the harness covering. 4. If terminal is to be replaced, cut the terminal between the core and insulation crimp to minimize wire loss. C. Terminal Crimping — VIM And Speed Sensor Terminals (Standard Crimping Tool) 1.

If a spare wire is used, the wire should be pushed through the proper hole in the strain relief (if used), through the wire seal, and out the other side of the connector before stripping. 2. Carefully strip insulation 4.5 mm ± 0.5 mm (0.18 ± 0.02 inch). Unless insulation crimp is over- tight, Automatic Wire Stripper J 35615 will remove insulation and crimp from old terminal with- out damaging wire. 3. Place core crimp portion of terminal on bed of anvil “E” and squeeze crimper enough to keep terminal from dropping (Figure E–2, View B). 4. Position wire core in terminal and squeeze crimper tool to complete the core crimp.

Be sure to ori- ent the terminal so that it is properly aligned with the terminal cavity in the connector. The terminal should be positioned so that the lock tang is on the side of the cavity which has the notch in the middle (for the remover tool). 5. Position insulation crimp of terminal on anvil “C” so that the entire insulation crimp area and a portion of the terminal between the core and insulation crimp areas are supported by the anvil. Complete the insulation crimp. 6. Be sure lock tang is lifted to allow proper reseating of the terminal. 7. Pull on the wire to pull the terminal completely into the cavity.

(A click will be heard and the terminal should stay in place if the wire is pushed.) D. Terminal Crimping Using Alternate Tool J 35123 1. If a spare wire is used, the wire should be pushed through the proper hole in the strain relief (if used) and the wire seal, and out the other side of the connector prior to stripping. 2. Insert remover tool in front side of connector to release locktab and push terminal out front of connector. Pull the terminal and wire out the front of the connector to complete Steps (3) through (7). 3. Push open the terminal holder on the crimper tool J 35123 and insert a terminal into the opening marked 18–16 (Figure E–2, View C) so that the crimp ends point up.

Release the terminal holder. 4. Slightly close the crimping tool (close until one click is heard) but do not start to crimp the terminal. Place the terminal on the wire so it is in the same position as it will be when pulled back into the connector. The terminal should be positioned so that the lock tang is on the side of the cavity which has the notch in the middle (for the remover tool). 5. Insert the wire into the terminal until the wire contacts the holder. (By doing this, the core and insulation should be properly positioned for the core and insulation crimp wings.) 6. Squeeze the crimper fully until it opens when released. E–10 Copyright © 2001 General Motors Corp.