WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS D. Terminal Crimping Using Alternate Tool J 35123 (cont’d) 7. Open the terminal holder and remove the wire and terminal from the crimping tool. 8. Pull on the terminal to assure a tight crimp. 9. Be sure lock tang is lifted to allow proper reseating of the terminal. 10. Pull on the wire to pull the terminal completely into the cavity. (A click will be heard and the terminal should stay in place if the wire is pushed.) Copyright © 2001 General Motors Corp. E–11