Industrial — 1–3. DELPHI-PACKARD METRI-PACK 150 SERIES CONNECTORS — PUSH- TO-SEAT (OIL LEVEL SENSOR)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–3. DELPHI-PACKARD METRI-PACK 150 SERIES CONNECTORS — PUSH- TO-SEAT (OIL LEVEL SENSOR) A.

Connector/Terminal Repairs Wire Stripper Crimping Tool J 35615 J 38125–7 Wire Crimp Anvil “E” Insulation Crimp Anvil “C” Alternate Crimping Tool J 35123 Remover Tool J 35689–A Use Description Manufacturers P/N Oil Level Sensor 4-Pin Design Used Prior To MD Family S/N 6510220479 and HD Family S/N 6610048466 (Except S/N 6610052000 through 6610052184) 4-Pin Receptacle (View B) Terminal (Pin) Secondary Lock, TPA 12047786 12047581 12047787 4-Pin Plug (View A) Terminal (Socket) Secondary Lock 12047785 12047767 12047664 Oil Level Sensor 3-Pin Design Used Starting With MD Family S/N 6510220479 and HD Family S/N 6610048466 (Except S/N 6610052000 through 6610052184) 3-Pin Plug (View B) Terminal (Socket) Secondary Lock, TPA 12064758 12047767 12047783 B.

Terminal Removal NOTE: Do not solder crimps. 1. Remove the secondary lock. 2. Insert needle end of terminal remover J 35689-A into the small notch between the connector and the terminal to be removed (Figure E–3, View A or View B). Push the lock tang toward the termi- nal. 3. Pull the wire and terminal out the rear of the connector (this is a “push-to-seat” terminal). 4. Pull terminal as far as necessary from the connector. This will be limited by the number of other wires inserted into the connector and by the distance between the back side of the connector and the beginning of the harness covering. 5.

If terminal is to be replaced, cut the terminal between the core and insulation crimp to minimize wire loss. Copyright © 2001 General Motors Corp. E–13