WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS C. Terminal Crimping 1. Carefully strip insulation 4.5 mm ± 0.5 mm (0.18 ± 0.02 inch). Unless insulation crimp is over- tight, Automatic Wire Stripper J 35615 will remove insulation and crimp from old terminal with- out damaging wire. 2. Place core crimp portion of terminal on bed of anvil “E” and squeeze crimper enough to keep terminal from dropping (Figure E–3, View D). 3. Position wire core in terminal and squeeze crimper tool to complete the core crimp.
Be sure to ori- ent the terminal so that it is properly aligned with the terminal cavity in the connector. The terminal should be positioned so that the lock tang is on the side of the cavity which has the notch in the middle (for the remover tool). 4. Position insulation crimp of terminal on anvil “C” so that the entire insulation crimp area and a portion of the terminal between the core and insulation crimp areas are supported by the anvil. Complete the insulation crimp. 5. Be sure lock tang is lifted to allow proper reseating of the terminal. 6. Push on the wire until the terminal is completely into the cavity.
(A click will be heard and the terminal should stay in place when the wire is lightly pulled.) D. Terminal Crimping Using Alternate Tool J 35123 1. Insert remover tool in front side of connector to release locktab and pull terminal out rear of connector. Pull the terminal and wire out the rear of the connector to complete Steps (3) through (7). 2. Push open the terminal holder on the crimper tool J 35123 and insert a terminal into the opening marked 18–16 (Figure E–3, View C) so that the crimp ends point up. Release the terminal holder. 3. Slightly close the crimping tool (close until one click is heard) but do not start to crimp the termi- nal.
Place the terminal on the wire so it is in the same position as it will be when pulled back into the connector. The terminal should be positioned so that the lock tang is on the side of the cavity which has the notch in the middle (for the remover tool). 4. Insert the wire into the terminal until the wire contacts the holder. (By doing this, the core and insulation should be properly positioned for the core and insulation crimp wings.) 5. Squeeze the crimper fully until it opens when released. 6. Open the terminal holder and remove the wire and terminal from the crimping tool. 7. Pull on the terminal to assure a tight crimp. 8.
Be sure lock tang is lifted to allow proper reseating of the terminal. 9. Push on the wire until the terminal is completely into the cavity. (A click will be heard and the terminal should stay in place if the wire is lightly pulled.) E–14 Copyright © 2001 General Motors Corp.