WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS C. Terminal Crimping (Refer to Figure E–10, View B) (cont’d) 3. Insert the contact end of the terminal into crimping tool J 34182. Adjust the crimping tool depth by loosening the locking ring until the depth adjusting screw is free and turning the adjusting screw until the top of the terminal is just above flush with the crimping hole (the crimp jaws will contact the middle of the terminal barrel). Tighten the lock ring to retain the adjustment. 4.
Fully insert the wire into the terminal so that the stripped portion of the wire is in the crimp area. A small section (0.5–1.0 mm (0.02–0.04 inch)) of wire will be visible above the terminal barrel. 5. Squeeze the crimping tool handle until it releases. The terminal is now crimped onto the wire. 6. Remove the terminal and wire from the crimping tool. 7. Tug on the terminal to ensure the crimp is tight. 8. For the optional DDR connector, apply a 25 mm (one inch) long piece of heat shrink tubing over the wire insulation just behind the terminal. Apply heat to shrink and lock tubing to the insulation. D. Terminal Insertion (ECD Bulkhead) NOTE:
If replacing an outside grommet (refer to Figure E–10 showing the ECD bulkhead), ensure the grommet is correctly installed. Each grommet hole is marked with the terminal ID of the wire that passes through that hole. The grommet holes match the pattern of either the pins or sockets in the connector. One side of the grommet is marked “PIN” and the other “SKT” or “SOC”. “PIN” indicates the pin (receptacle) side of the connector and “SKT” or “SOC” the socket (plug) side. When installing the outer grommet in the receptacle, ensure “PIN” is showing and positioned so that the “A” terminal ID on the outer grommet aligns with the “A” terminal ID on the inner grommet.
When installing the outer grommet in the plug, “SKT” or “SOC” must be showing and positioned so that the “A” terminal ID on the outer grommet aligns with the “A” terminal ID on the inner grommet. Reversing “PIN” and “SKT” or “SOC” sides of the grommet will cause the grommet holes to be misaligned with the holes in either the receptacle or plug. Perform Steps (1) and (2) only if the outer grommet has been removed. 1. Place the correct side of the grommet upwards with the inner and outer grommet “A” terminal ID aligned. 2. Insert two cavity plugs in unused cavities to retain the grommet. NOTE: When using remover/inserter tool J 41194, take care not to break the tip of the tool.
Lay the wire in the widest part of the wire slot and work toward the tool tip. 3. Place the terminal and wire in the end of extractor/inserter tool J 41194. 4. Insert the tool through the grommet, into the back of the connector, and push until the terminal is seated. Remove the remover/inserter tool. 5. Insert cavity plugs into all unused cavities. 6. Wrap plastic electrical tape around the wire bundle. 7. Reassemble the connector in the reverse order of disassembly. E. Terminal Insertion (all connectors except ECD bulkhead) 1. Insert wire with crimped terminal through the proper hole in the grommet. 2. Keep pushing on wire until the terminal “locks” into position.
Copyright © 2001 General Motors Corp. E–33