WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–12. DEUTSCH DT SERIES CONNECTORS (3-WAY J1939 INTERFACE) A.
Connector/Terminal Repair Crimping Tool J 34182 Use Description Manufacturers P/N J1939 Interface (Early Design) Connector, Plug, 3-Way Wedgelock, Plug Connector, Plug, 3-Way Wedgelock, Plug (Green — Diagnostic/ Controller Stubs) Connector, Receptacle, 3-Way Wedgelock, Receptacle Contact, Pin #16 Contact, Extended Pin Contact, Socket (Standard) Contact, Socket (Extended) DT06-3S-E008 W3S-1939 DT06-3S-P032 W3S-P012 J1939 Interface (Later Design) Common To Both Designs DT04-3P-E008 W3P 3660-201-1690 0460-247-1631 3662-204-1691 0462-221-1631 B. Terminal Removal (Refer to Figure E–13) 1. Use a small-bladed screwdriver to remove the secondary lock that holds the terminals in place. 2.
Use a sharp knife to carefully remove the shrink tubing from the rear of the connector plug. 3. Use a small screwdriver to release the locking lever for all of the terminals. Pull the wire and ter- minal out the rear of the connector. 4. Slide a new piece of shrink tubing over the removed terminals and onto the cable. 5. If replacing the terminal, cut the wire through the middle of the terminal crimp to minimize wire loss. C. Terminal Crimping (Refer to Figure E–13) 1. Strip 6–8 mm (0.24–0.31 inch) of insulation from the wire. (There is no insulation on the shield wire.) 2. Set the crimping tool wire size to number 18. To set the wire size, remove the retainer pin.
Lift and rotate the indicator until 18 is aligned with the SEL NO. arrow. Reinstall the retainer pin. 3. Insert the contact end of the terminal down into crimping tool J 34182. Adjust the crimping tool depth by loosening the locking ring until the depth adjusting screw is free and turning the adjusting screw until the wire end of the terminal is just above flush with the top of the crimping hole. The depth adjustment screw will need to be backed out a large amount to accept the extended shield terminal. The crimp jaws will now contact the middle of the terminal barrel. Tighten the lock ring to retain the adjustment. 4.
Fully insert the wire into the terminal so that the stripped portion of the wire is in the crimp area. A small section (0.5–1.0 mm (0.02–0.04 inch)) of wire will be visible above the terminal barrel. 5. Squeeze the crimping tool handle until it releases. The terminal is now crimped onto the wire. Copyright © 2001 General Motors Corp. E–43