Industrial — 1–12. DEUTSCH DT SERIES CONNECTORS (3-WAY J1939 INTERFACE)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS C. Terminal Crimping (Refer to Figure E–13) (cont’d) 6. Remove the terminal and wire from the crimping tool. 7. Tug on the terminal to ensure the crimp is tight. D. Terminal Insertion 1. Slide the wire with crimped terminal attached into the rear of the connector. 2. Push the terminal and wire into the connector until it locks into position (refer to Figure E–13). Check the front of the connector to see that the terminal is at the same height as other terminals.

Tug on the wire at the rear of the connector to ensure that the terminal is locked in place. 3. Insert the wedge lock to hold the terminals in place. Slide the sealing plug back into place at the rear of the connector. 4. Slide the shrink tubing over the raised area at the rear of the connector. Use a heat gun to shrink the tubing into position over the connector and cable. E–44 Copyright © 2001 General Motors Corp.