Industrial — 1–13. AMP MATE-N-LOK II SERIES CONNECTORS (COMPACT SHIFT SELECTOR)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–13. AMP MATE-N-LOK II SERIES CONNECTORS (COMPACT SHIFT SELECTOR) NOTE: The repair information for the AMP connector was obtained from the following AMP publications: Application Specification 114–16016; 20 NOV 95; Rev D Instruction Sheet 408–9999; 10 JAN 95; Rev A Instruction Sheet 408–9592; 22 JUL 93; Rev O The following information is presented for the convenience of Allison Transmission customers using the compact shift selector. Connector parts and AMP repair tools are not available through Allison Transmission.

For availability of parts and tools, contact: AMP Incorporated Customer Service; P.O. Box 3608; Harrisburg, PA 17105-3608 Technical/Tooling Assistance Center 1-800-722-1111 AMP FAX/Product Info 1-800-522-6752 A. Connector/Terminal Repair AMP PRO-CRIMPER II Hand Tool Assembly with Die Assembly AMP Hand-Crimping Tool (Alternate) 58529-1 58529-2 58440-1 Use Description Manufacturers P/N Compact Pushbutton Shift Selector Shift Selector Assembly (Serviced only as an assembly) Mating 14-Way Connector Terminal, Socket Seal Plug Wire Seal (14-Way) Connector Seal 15752787 1-778273-1 770854-3 770678-1 B. Terminal Removal (Refer to Figure E–14, View A) 1.

Disconnect the connector from the compact shift selector when repairs are being made. 2. Insert a 4.8 mm (0.188 inch) wide screwdriver blade between the mating seal and one of the red wedge lock tabs. Pry the wedge lock to the open position. Wedge lock will move outward about 5.5 mm (0.22 inch). NOTE: Any of the wires may be removed for servicing with the wedge lock in the open position. DO NOT remove the wedge lock in order to service terminals. 3. To remove a wire and terminal from the connector: Rotate the wire back and forth through a half-turn arc (quarter turn in each direction) and gently pull on the wire until the terminal is removed. 4.

If replacing the terminal, cut the wire through the middle of the terminal crimp to minimize wire loss. Copyright © 2001 General Motors Corp. E–47