WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS E–48 Copyright © 2001 General Motors Corp. C. Terminal Support Adjustment (Figure E–14, View B) NOTE: The terminal support is preset prior to tool shipment, but minor adjustment may be necessary. 1. Make a sample crimp and determine if the terminal is straight, bending upward, or bending downward. 2. If adjustment is required, loosen the screw that holds the terminal support onto the locator assembly. NOTE: The tool ratchet has detents that produce audible clicks as the tool handles are closed. 3.
Place a terminal and wire into the 18 wire gauge nest and close the tool handles until the ratchet reaches the sixth click, or until the terminal support touches the terminal. 4. Slightly loosen the nut that holds the locator assembly onto the tool frame. 5. Move the terminal support as required to eliminate the bending of the contact. 6. Tighten the nut and close the handles until the ratchet releases. 7. Remove and inspect the terminal. 8. Make another sample crimp. If the contact is straight, tighten the terminal support screw. If the ter- minal is still being bent during crimping, repeat the adjustment procedure. D.
Terminal Crimping Using AMP PRO-CRIMPER II (Refer to Figure E–14, View B) 1. Strip 4.7–5.5 mm (0.18–0.22 inch) of insulation from the wire, being careful not to nick or cut wire strands. NOTE: Be sure that the wire stripper does not leave indentations on the surface of the wire insulation. If indentations are present in the area of the wire seal, leakage may result. The insulation surface within 26 mm (1.02 inch) from the tip of the terminal must be smooth and free of residual indentations. 2. Position the tool so the back (wire side) is facing you. Squeeze the tool handles together and allow them to open fully. 3.
Holding the terminal by the mating end, insert the terminal — insulation barrel first — through the front of the tool and into the 18 wire gauge crimp section. 4. Position the terminal so the mating end of the terminal is on the locator side of the tool and the open “U” of the wire and insulation barrels face the top of the tool. Place the terminal up into the 18 gauge nest so the movable locator drops into the slot in the terminal. Butt the front end of the wire barrel against the movable locator. CAUTION: Ensure both sides of the insulation barrel are started evenly into the crimping section. DO NOT attempt to crimp an improperly positioned terminal. 5.
Hold the terminal in position and squeeze the tool handles together until the ratchet engages sufficiently to hold the terminal in position. DO NOT deform the insulation barrel or the wire barrel. 6. Insert the stripped wire into the terminal and wire barrels until the wire is butted against the locator/wire stop.