Industrial — 1–13. AMP MATE-N-LOK II SERIES CONNECTORS (COMPACT SHIFT SELECTOR)

Copyright © 2001 General Motors Corp. E–49 WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS D. Terminal Crimping Using AMP PRO-CRIMPER II (Refer to Figure E–14, View B) (cont’d) 7. Holding the wire in place, squeeze the tool handles together until the ratchet releases. Allow the tool handles to open and remove the wire with the crimped terminal attached. NOTE: Release a terminal stuck in the crimping nest by pushing downward on the top of the movable locato 8. Be sure the finished crimp meets the size requirements shown in Figure E–14, View C. E.

Terminal Crimping Using Alternate Crimper 58440-1 (Refer to Figure E–15) 1. Strip 4.7–5.5 mm (0.18–0.22 inch) of insulation from the wire, being careful not to nick or cut wire strands. NOTE: Be sure that the wire stripper does not leave indentations on the surface of the wire insulation. If indentations are present in the area of the wire seal, leakage may result. The insulation surface withi 26 mm (1.02 inch) from the tip of the terminal must be smooth and free of residual indentations. 2. Position the tool so the back (wire side) is facing you. Ensure the tool ratchet is released by squeezing the tool handles and allowing them to fully open. 3.

Holding the terminal by the mating end, insert the terminal — insulation barrel first — through th front of the tool and into the 18 wire gauge crimp section. 4. Position the terminal between the crimping dies so the locator/insulation stop drops into the slot i the terminal. Butt the front end of the wire barrel against the locator/insulation stop. r. n e n INSULATION ADJUSTMENT FRONT OF TOOL BACK SIDE CONTACT LEVER (WIRE SIDE) SUPPORT F CONTACT AMP LOCATOR DIE INSERT SUPPORT CRIMP SECTION WIRE SIZE ANVIL MARKING WIRE SLOT 58440-1 IN LOCATOR UPPER INSERT WIRE BARREL IN LOCATOR LOCATOR SLOT STRIPPED (IN CONTACT) WIRE CAUTION:

CERTI-CRIMP * The crimping jaws bottom before the RATCHET CERTI-CRIMP* ratchet releases. This is a design feature that ensures maximum electrical and tensile performance of the crimp. DO NOT re-adjust the ratchet. V07112 Figure E–15. Alternate AMP Crimper 58440-1