WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS F J 38125-8 G V01694 Figure E–16. Crimper J 38125-8 C. Straight Lead Repair Procedure 1. Locate damaged wire. 2. Remove insulation 8.0 mm (0.3 inch). 3. Insert one wire into crimp barrel and crimp. 4. Insert other wire into crimp barrel and crimp. 5. Pull on connection to ensure crimping integrity. 6. Heat splice with heat gun until covering shrinks and adhesive flows from under the covering. 7. The splice is now sealed and insulated. Electrical tape should not be used and is not necessary. E–52 Copyright © 2001 General Motors Corp.