WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–14. REPAIR OF A BROKEN WIRE WITH IN-LINE BUTT SPLICE A. Connector Check Before Repair NOTE: Before repairing or replacing wiring harness, sensor, solenoid, switch, or ECU as indicated for a diagnosed problem, follow the procedure below: 1. Disconnect the connector or connectors associated with the problem and inspect for: Bent terminals Broken terminals Dirty terminals Pushed back terminals Missing terminals Condition of mating tabs Condition of mating terminals Ensure that terminals are secure in the connector.
Clean, straighten, or replace parts as required. 2. Reconnect all previous unmated connectors. Ensure connectors are fully inserted or twisted until they lock in place. Connectors with locking tabs make an audible “click” when the lock is engaged. 3. If trouble recurs after starting the vehicle, follow proper repair procedures for trouble code or complaint. 4. If trouble does not recur, or if the correct repairs and/or replacements have been made, the problem should be corrected. B. Special Tools Heat Gun, J 25070 or equivalent Crimping Tool for Pre-insulated Crimp J 38125-8 (refer to Figure E–16) NOTE:
Use crimping anvils “F” and “G.” Wire Stripper, J 35615 Splices P/N 23046604 14–16 AWG Splices P/N 23046605 18–22 AWG NOTE: Each splice must be properly crimped and then heated to shrink the covering to protect and insulate the splice. Insulation piercing splice clips should not be used. Copyright © 2001 General Motors Corp. E–51