Industrial — APPENDIX F — THROTTLE POSITION SENSOR ADJUSTMENT

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX F — THROTTLE POSITION SENSOR ADJUSTMENT MOUNTING PROVISION: Use M6 x 1.00 or 1 4 -20 in. series bolts 3 places Torque M6 x 1.00 bolt to 10–13 N•m (84–120 lb in.) Torque 1 4 -20 in. series bolts to 13–14 N•m (108–132 lb in.) Mount to a solid frame member. Flatness of chassis mounting surface must not exceed 0.8 mm (0.03 in.). BENDING LOAD APPLIED UNACCEPTABLE INSTALLATION 10.0 ° MAX INSTALLED OPERATING ANGLE IN ALL DIRECTIONS LOADING IN TENSION ONLY Attachment must provide freedom of motion to allow cable loading in tension only (no bending loads).

ACCEPTABLE INSTALLATION WIRING HARNESS 55.0 mm (2.17 in.) MIN REQUIRED FOR CONNECTION REMOVAL Fuel control must not move the throttle sensor beyond the closed throttle position at any time. R 152.0 mm (6.00 in.) MIN ALLOWANCE RADIUS FULLY EXTENDED FORCE REQUIRED 26.7 N (6.0 LB) MAX FULLY RETRACTED ( NOTE: Mounting length + 50.8 mm (2 inches) equals cable length) CLOSED THROTTLE 95.2 mm (3.75 in.) MOUNTING LENGTH FULL THROTTLE 118.1 mm (4.65 in.) 47.5 mm (1.87 in.) 118.1 mm (4.65 in.) OPERATING BAND 15.2 – 22.9 mm (0.6 – 0.9 in.) The location of the clamping bracket relative to the fuel lever at closed throttle must be maintained within this range.

Attach to engine or governor housing using clamp and shims as required. Clamp must positively lock in cable groove. 30.2 mm (1.19 in.) 93.45 mm (3.679 in.) 87.15 mm (3.431 in.) Fuel lever attachment linkage or bracket must allow fuel lever to return to closed throttle position when sensor rod is maintained at full throttle position. Attach the throttle sensor directly to the engine fuel lever with no breakover or yield linkages between the engine fuel lever shaft and the attachment point of the throttle sensor.

ENGINE FUEL LEVER HITCH PIN CLIP CLOSED THROTTLE 183.1 mm (7.21 in.) MAX SAME AS WITHOUT SLIP-LINK FULL THROTTLE 160.2 mm (6.31 in.) MIN FULLY EXTENDED 38.1 mm (1.50 in.) FULLY RETRACTED HITCH PIN CLIP OPTIONAL THROTTLE SENSOR ASSEMBLY WITH SLIP-LINK V00430.07 Figure F–3. Throttle Position Sensor Adjustment Copyright © 2001 General Motors Corp. 95.2 mm (3.75 in.)