WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX G — WELDING ON VEHICLE/VEHICLE INTERFACE MODULE Copyright © 2001 General Motors Corp. 1–1. WELDING ON VEHICLE When frame or other welding is required on the vehicle, take the following precautions to protect the electronic control components: 1. Disconnect the wiring harness connectors at the transmission electronic control unit. 2. Disconnect the positive and negative battery connections, and any electronic control ground wires connected to the frame or chassis. 3. Cover electronic control components and wiring to protect them from hot sparks, etc. 4. Do not connect welding cables to electronic control components. WARNING!
Do not jump start a vehicle with arc welding equipment. Arc welding equipment’s dangerously high currents and voltages cannot be reduced to safe levels. 1–2. VEHICLE INTERFACE MODULE The Allison Vehicle Interface Module (VIM) containing all Allison system relays and fuses must be used as the interface to all vehicle wiring. Refer to Figure G–2 for VIM component location and pin-out.To close an open VIM, tighten the bolts in the numerical order shown in Figure G–1 to provide a sealed, water-tight box. Torque the bolts to 5–8 N·m (4–6 lb ft). 2 6 7 4 3 5 8 1 V00657 Figure G–1. Vehicle Interface Module